When it comes to small loaders, I believe everyone is familiar with it. Under the rapid development of modern villages and towns, it is not difficult to find its presence as long as there is a place for construction. It is inevitable that various problems will occur when small loaders are used on a large scale. Among them, the internal leakage of steering cylinder is a thorny problem, which will lead to heavy steering of loaders. How can we judge whether the oil cylinder is leaking? The following editor will teach you:

1、拆卸與右轉向油缸大腔相連的液壓膠管和接頭，把油管插在油桶里約3min，待缸頭端余油不流動后重新打車，繼續操作右轉向，切記此時不能向左打轉向，否則會造成拆掉的液壓膠管噴油和方向失控，并觀察右轉向油缸大腔油口流油情況。

1. Remove the hydraulic hose and connector connected to the large chamber of the right steering cylinder, insert the oil pipe into the oil barrel for 3min, and then take a taxi again after the residual oil at the cylinder head end does not flow. Continue to operate the right steering. Remember not to turn to the left at this time, otherwise the oil injection and direction of the removed hydraulic hose will be out of control. Observe the oil flow at the oil port of the large chamber of the right steering cylinder.

2、測算油滴的時間，此時轉向油路一直處于憋壓狀態，拆掉的膠管由于與轉向器回油口相通持續有油流，這個過程約30-60秒即可。

2. Measure the time of oil drop. At this time, the steering oil circuit is always in a pressure holding state. Since the removed rubber hose is connected with the oil return port of the steering gear, there is continuous oil flow. This process takes about 30-60 seconds.

以上就是為大家介紹的瓦斯發電機組http://m.dgtmcnc.com有關的詳細的介紹,希望對您有所幫助.如果您有什么疑問的話,歡迎聯系我們.我們將以專業的態度,為您提供服務.

The above is the gas generator set introduced to you http://m.dgtmcnc.com I hope that the detailed introduction to the will be helpful to you If you have any questions, please contact us We will provide you with professional service